Winter maintenance of diesel generator sets

Introduction: In winter, when the temperature is low, starting a diesel engine can be difficult, and at the same time, the diesel engine wears, because at this time, the intake air temperature, the cooling water temperature, the lubricant temperature, the fuel temperature, and the temperature of the electrolyte in the battery are all corresponding. reduce. Therefore, the maintenance of diesel generators is very important.

Winter maintenance of diesel generator sets

Diesel generator set is a kind of small-scale power generation equipment, which refers to the power machinery that uses diesel fuel as fuel and uses the diesel engine as the prime mover to drive the generator to generate electricity. Diesel generator sets generally consist of diesel engines, generators, control boxes, fuel tanks, storage batteries for start-up and control, protective devices, and emergency cabinets. The whole can be fixed on the basis of positioning and can also be mounted on a trailer for mobile use.

Nearly 30% of the failures in the unit's failure to initiate repairs are: The unit has started a battery failure. For example, the battery is unmaintained for a long time, the electrolyte is not replenished in time after the water evaporates, the battery charger is not configured, and the battery has a long time. After the natural discharge, the power is reduced; or the charger to be used needs manual periodical equalization/floating charge switching, and the battery power does not meet the requirement due to negligence of the switching operation.

In addition, during daily inspections of diesel generators, it is difficult for non-professionals to find small traces, which usually lead to major failure of the unit and render it unusable. Wait until the emergency unit needs to start the unit to find out that the equipment cannot operate. Wait until the repair and maintenance personnel arrive at the site to judge the fault, determine the maintenance plan, and then begin to purchase the spare parts and repair it to the end. At least 10 days or a half month later, the loss caused has no result. Recall.

PCB Cutting Machine

This type of SF-706 machine have to keep PCB board,the circular blade is moving.It is suitable for Special height for ultra high component can be 70mm.

This type of SF-701machine through adjust the height of track manually and control At 0.01 mm to solve the problem of V-CUT depth. Accept made to order super high components on the PC board such as power supply.The highest for 400mm is also accepted to customize.

The type of SF-705 v notch PCBA Cutting Machine which is suitable for Thickness of the to-be-cut base plate: 0.5-2.0mm, max. length of 300mm PC plate. Then Processing V-PCD plate, aluminum plate and CUT plate, etc.The using way is Controlled by electric pedal or pneumatic pedal, hoe knife plate splitting is completed by the motion of air cylinder.

The type of SF-716 machine is used for visual PCB depanel.

Visual Platform Desktop Separator,V-cut PCB Cut Depaneling Machine,PCB V-cut Cutting Machine

SINGSUN ELECTRONIC SCIENCE & TECH CO.,LTD , https://www.singsunautomatics.com

Posted on