Brake system maintenance and maintenance

Replace brake pads by mileage. Brake pads and brake discs (drums) have a service life and must be replaced when they are worn to a certain degree. Normal use in normal city driving, their life span is about 50,000 kilometers, and the life of brake pads is about 30,000 kilometers. However, the specific situation depends on the operation of the owner, and it is best to check once every 10,000 kilometers. However, when the brakes are applied, the car is obviously running to the left or right. This is caused by the non-synchronous front-wheel brakes. It is very easy to accidentally grab the left (right) brake and cause an accident. Especially when driving at high speed, you must immediately go to the repair shop. Perform brake adjustments.

In addition, the new car should pay attention to the braking system running in. The first 1000 km of new car is crucial for running-in. The braking system also needs to run in. It is better not to have emergency braking. In order to run smoothly, the clutch must be depressed before stepping on the brakes, but this is only a temporary expedient. After 1000 km, in order to extend the life of the clutch, it is still necessary to “disconnect from the brakes.”

Oxide Ceramics Powder

Oxide powder for thermal spray refers to a type of powder material that is used in thermal spray processes. Thermal spray is a coating technique where a material in powder form is heated and propelled onto a substrate, forming a coating.

Oxide powders are commonly used in thermal spray applications due to their high melting points, excellent wear resistance, and thermal insulation properties. They can be used to create protective coatings on various surfaces, such as metals, ceramics, and plastics.

Some common types of oxide powders used in thermal spray include:

1. Aluminum oxide (Al2O3): This oxide powder is widely used for its high hardness, wear resistance, and thermal insulation properties. It is commonly used for coating applications in industries such as aerospace, automotive, and electronics.

2. Zirconium oxide (ZrO2): Zirconium oxide powder is known for its high melting point and excellent thermal barrier properties. It is often used in thermal spray coatings for gas turbine engine components, where thermal insulation is critical.

3. Chromium oxide (Cr2O3): Chromium oxide powder is used for its high hardness, corrosion resistance, and wear resistance. It is commonly used in applications where high temperature and abrasive wear resistance are required.

4. Titanium oxide (TiO2): Titanium oxide powder is known for its high refractive index and excellent UV resistance. It is often used in thermal spray coatings for optical and decorative applications.

These oxide powders can be applied using various thermal spray techniques, such as flame spraying, plasma spraying, or high-velocity oxy-fuel (HVOF) spraying. The choice of oxide powder and thermal spray technique depends on the specific application requirements and desired coating properties.

Oxide Ceramics Powder,Pure Aluminum Oxide Powder,Chromium Oxide Ceramics Powder,Yttria Stabilized Zirconia Powder

Luoyang Golden Egret Geotools Co., Ltd , https://www.lyshieldcutters.com